Emergency Tube FAQ

🔧 Aleddra Emergency Tube Model Comparison

Q1: What is the Aleddra Self-Testing Emergency LED Tube?

The Aleddra Self-Testing Emergency LED Tube is a dual-mode LED tube that functions as both a regular light source and a built-in emergency light during power outages. It automatically switches to emergency mode and provides illumination for up to 90 minutes using its internal battery.
What sets Aleddra apart is its self-testing feature, which automatically runs a 30-second monthly test and a 90-minute annual test—no human intervention required.

Q2: Can Aleddra’s “lockable” socket be used with non-PRO emergency tubes?

Yes. Aleddra’s lockable socket can be used with non-PRO model tubes, but it must be ordered as a separate line item.

Q3: How does the Aleddra Self-Testing Emergency Tube schedule its monthly and annual self-tests?

Once installed, the tube automatically sets its test cycle based on the installation time.
For example, if the tube is installed at 1:00 PM, both the monthly and annual tests will be scheduled to begin at 1:00 PM.
You can reset the test cycle by holding the test button for 6 seconds at a new time—e.g., press and hold at 8:00 PM to reschedule future tests to begin at that time.

Q4: If the Aleddra Self-Testing Emergency Tube fails a test, what happens?

If the tube does not pass its self-test, the LED indicator light will flash rapidly and continue flashing until the faulty tube is replaced. This provides a clear visual alert that maintenance is required.

Q5: How do third-party emergency tubes handle testing?

Third-party emergency tubes typically rely on manual testing. Here’s how they work:

• The user must manually push a test button to start the cycle.
• Most cannot distinguish between a 30-second test and a 90-minute test.
• Unless the test is manually stopped, the tube will run the full 90-minute test every time, even monthly.

This can drain the battery prematurely, leading to shortened lifespan and failure to meet the emergency runtime during the product’s warranty period.

Q6: What does a customer need to do to test competitor emergency tubes?

Most third-party tubes require customers to:

• Turn off the breaker controlling the emergency fixtures, OR
• Use a ladder to access and press the test button, OR
• Use a stick to reach the button if the fixture is open, OR
• Use a remote device to trigger the test

Then, the user must:

• Time the test for 30 seconds or 90 minutes
• Manually stop the test to avoid a full 90-minute cycle
  If the test isn’t stopped, the tube will run the full duration—damaging battery life and increasing maintenance risk.

Q7: What does the customer need to do to test an Aleddra Emergency Tube?

Nothing at all.

With Aleddra’s Self-Testing Tubes (G3PLUS, G4, and G4PRO Series):

• The tube automatically runs the 30-second monthly test and 90-minute annual test
• The indicator LED will alert you if the tube fails
  No ladders. No breaker shutdowns. No manual timing.
  This patented self-testing feature ensures code compliance, operational reliability, and reduced labor costs.

Q8: I have a customer looking for a 4ft emergency LED tube that works with a motion sensor. Will the Aleddra LLT-4-EM-T8-G3PLUS-15W-50K work in this case?

No, the G3PLUS model is not compatible with motion sensors.
However, the G4 EM T8 is motion sensor compatible.
The recommended part number is: LLT-4-EM-T8-G4-15W-3CCT

Wiring Instructions:

• Red-labeled endcap: Connect to a constant-on circuit (L and N) to charge the internal battery.
• White endcap: Connect to a switched circuit (L and N) controlled by the motion sensor.